The Top led neonflex is called vertical bending led neonflex, its FPC is on the bottom of the neonflex, when install product, need to top/vertical bending, and the bending diamater should >its min bending diameter, let’s check its installation guidance so as to avoid the problem caused by incorrenct installation.

At Hanky, the top bending led neonflex is mainly has the size as bellowed:

The operation is forbidden in order to avoid the led neonflex failed as bellowed:

The bending diameter should be bigger than the min bending diameter, if the bending diameter is too samall, the FPC will crack and the neinflex will not work any more.

The led neonflex could be cut and re-connect based on the requirement of the project site, let’s check the step as bellowed, it’s quite easy to the installer.

Various installed way could be choosed, such as the clip installation, profile installation and suspension installation(only 16*15mm and 12*12mm have such installation).

At this part, should done as same as the notice said bellowed:

At side top installation, it need done by two persons and complied with the instructions bellowing:

At top installation, the 2-15M need done by two persons, and comply with the instructions as bellowed: